Conditions of Use

Users instructions

When stringing the bow, the lower end of it must not touch the ground and the upper end must be held and pressed under the bezel.

The middle of the hilt should lean up on the inside part of the thigh, while the lower end of the bow above the bezel should lean up on the outside of your lower leg. Before using set the string in the middle of the siyahs. n the course of using the bow keep that part upwards where you can see the name Grozer. (at Grozers bow)

The C-shaped and composite bows should be strung crouching, the bow pressed to the knees. Before using set the string in the middle of the siyahs. If the siyahs twisted during the stringing of the bow, they have to be set to the middle as well by twisting it to the opposite direction. If the C-shaped bows are strung improperly its assymetry can be too much, so it should be twisted to the other direction to get the appropriate assymetry of the limbs.

NEVER shoot an arrow straight up into the air. Do not draw back and release the string without any arrows.

NEVER lean on the bow when drawn. After use, take the string off. After exteneded use the string may get thready and need waxing.

When waxing, pull the wax onto the string with fast motions.

NEVER leave a drawn bow in direct hot sun or in a car that is in a hot sun. If the bow gets very hot (e.g. having been carried in a car in summer) always wait until it cools down before stringing.

NEVER draw the bow over the maximum draw length given above.

Each draw weight is given on 28 col. (except for the Kassai bows, draw weight is given on 30 col)

The bows are quaranteed for one year from the date of purchase!

In the case of the bows that contain horn plates, sinew plates surface defects, cracks, tiny hair-cracks might occur.
These are inseparable from the natural features of these materials.

About hornbows

There are some important things to know about hornbows.
After stringing they are not symmetric at all. They must be set. Set quickly and confidently. This means the following:
String the bow very slowly. Limbs bend really slowly.
Right after stringing correct the asymmetry very quickly. Within seconds tilt it over, tilt opposite to the deformation – two or three times more than it has bended. Then set it back.
This must be done especially after the bow has not been strung for a long time or if we buy an extremely C shaped bow.
The other thing is regarding hornbows that their material is never homogenous. This means that teh surface of the sinew, the bone plate and the horn plate is NEVER smooth.
Grooves or any roughnesses always occur in the horn.
Please only buy a hornbow if you can respect these, if you count these and trust our knowledge completely.